English – B
English
WARNINGS
open and has come to a standstill.
• Do not let children play near the gate or with its commands.
• Keep the transmitters away from children.
• Suspend the use of the automation immediately as soon as you notice something abnormal in the operation (noises or jolting move -
• Do not touch moving parts.
If the safety devices do not work properly or are out of order, the gate can still be operated.
01. -
ds and keep the control activated.
02.
If the safety devices are out of order, arrange to repair the automation as soon as possible.
Manually
releasing and locking the gearmotor
Manual operation must be performed in the case of a power outage or in the event of anomalies aecting the system. In case of a power outage, a
back-up battery can be used (model PR100 - not supplied) (see Chapter 9 - Further information, or the relevant instruction manual).
In the event of a gearmotor fault, it is still possible to try release the motor to check whether the fault lies in the release mechanism.
-
Replacing the transmitter battery
transmitter to attempt to send the command.
However, if the battery level is too low to complete the command (and possibly wait for the response), the transmitter will turn o and the relevant Led
will fade. In these cases, normal transmitter operation can be restored by replacing the battery with another of the same type, while observing the
relevant polarity. To replace the battery, proceed as shown below.
local regulations.
a b c d
11
ESSENTIAL SAFETY REQUIREMENTS
To Next Page
Loading...
