Nice Filo

A – English
English
Table 12 contains useful information to help solve any malfunctions that may occur during installation or in case of a fault.
TABLE 12
Symptoms Probable cause and possible solution
The radio transmitter does not emit any signal
and the corresponding Led fails to light up
The manoeuvre fails to start and the
ECSBus led on the control unit does not
• Check that the power
cable is correctly inserted in
the power outlet.
have tripped, determine the
cause of the fault and repla -
ce them with others of the
Fig. 34
for model
FILO400C and FILO600C
Fig. 35
for model
FILO4 00ST/ AU01 a n d
FILO600ST/AU01
* Not present in
FILO 40 0SP/AU 0 1 a n d
FILO600SP/AU01
fuse
3.15A T
fuse
1A T
34
The manoeuvre fails to start and the auto - Check that the command is actually received. If the command reaches the SbS input, the rele -
The manoeuvre fails to start and the auto - • Check that the Stop input is active (in other words, that the Stop Led is lit). Should this not be
the case, check the device connected to the Stop input.
check the photocells, by verifying their status in Table 7.
The manoeuvre starts but is immediately
followed by a reverse run commanded by
the control unit
obstacles obstructing the gate’s movement and, if necessary, select a higher force as described
in Par. 9.1.1.
The manoeuvre is carried out but the
V~
10
TROUBLESHOOTING
fuse
1A T
fuse
1.6A T
250 V
*
35
11