Nidec COMMANDER S100 - Page 35

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Running the
motor
Drive
parameters
Communications Diagnostics Technical data
UL Listing
Information
Commander S100 User Guide 35
T12 Digital Input 2
T13 Digital Input 3
T14 Digital Input 4
Programmable Digital Inputs
T12 Default
Function
Enable
T13 Default
Function
Run Forward
T14 Default
Function
Run Reverse
Function Select
Parameters
T12 Digital Input 2 Function (P6.17)
T13 Digital Input 3 Function (P6.18)
T14 Digital Input 4 Function (P6.19)
Default Logic Positive Logic
Lower Threshold < 9 V
Upper Threshold > 10 V
Absolute
maximum applied
voltage range
-8 V to +30 V relative to 0V
Impedance 6.8 kΩ
Voltage Range 0 V to +24 V
Sample rate 4 ms
T15 Digital Input 5
Programmable Digital Input or Frequency Input
T15 Default
Function
Ref Switch Bit 0
Function Select
Parameter
T15 Digital Input 5 Function (P6.20)
Default Logic Positive Logic
Lower Threshold < 9 V
Upper Threshold > 10 V
Absolute maximum
applied voltage
range
-8 V to +30 V relative to 0V
Impedance 6.8 kΩ
Voltage Range 0 V to +24 V
Sample rate 4 ms
As a Frequency Input
Maximum
Frequency
100 kHz
Low Level
< 5 V
High Level
> 15 V
T41 Relay Normally Open
T42 Relay Common
T43 Relay Normally Closed
Programmable Relay
Relay Default
Function
Drive Healthy
Function Select
Parameter
T41-T43 Relay Function Select (P6.08)
Contact Voltage
Rating
240 Vac, installation over-voltage category II
Contact Maximum
Current Rating
2 A A.C. 240 V
4 A D.C. 30 V resistive load
0.5 A D.C. 30 V inductive load (L/R = 40 ms)
Minimum
Recommended
Voltage Rating
and Current
12 V 100 mA
Update Rate 10 ms