Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Running the
motor
Drive
parameters
Communications Diagnostics Technical data
UL Listing
Information
42 Commander S100 User Guide
5.5 Understanding the menu structure
The drive parameters, status, and monitoring values can be found within three modes: Status, Parameter Select and Parameter Edit.
Status
The primary mode of the drive that is used to provide users with an indicator to show the current status of the system, see Table 5-2. If the keypad is
to be used to provide a drive frequency reference, the display must be in Status for the user to be able to edit the reference using the UP and
DOWN buttons. If the drive is running, Status will show one of five monitoring parameters and the user can rotate between these by holding the
Settings button . The monitoring parameters that can be shown are as follows:
Ramp Output (Hz)
Output Voltage (V)
Output Current (A)
Output Speed (rpm)
Drive Load (%)
Parameter select
From Status users can move to Parameter Select by pressing the Settings button . Parameter Select allows the user to navigate through the drive
parameters. Users can scroll up and down the list of individual parameters by pressing the UP and DOWN buttons or they can switch between
different menus by holding the UP button to move to the next menu or the DOWN button to move to the previous menu.
Parameter edit
Once the desired parameter has been located in Parameter Select, the parameter value can be viewed or edited by pressing the Settings button .
The units of the selected parameter will be shown on the display. To edit the value of the parameter, the UP or DOWN buttons should be
pressed to increase or decrease the value as appropriate. Holding the UP or DOWN buttons will move the cursor left or right
respectively. The digit currently being edited will flash. Status & Monitoring parameters in Menu 1 are read only and cannot be edited.
Once the change has been made, exit to Parameter Select by pressing the Settings button or exit to Status by holding the Settings button .
All parameters changes are saved immediately after exiting Parameter Edit.
5.6 Saving parameters
Parameter changes are saved automatically after editing by pressing or holding the Settings button to return to Parameter Select or Status
respectively. To save parameter changes over communications, Save Parameters (P4.19) should be set to 1. After saving the parameter will reset
to 0.
To Next Page
Loading...
