Nidec COMMANDER S100 - Using the Keypad

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Running the
motor
Drive
parameters
Communications Diagnostics Technical data
UL Listing
Information
40 Commander S100 User Guide
5.4 Using the keypad
The Commander S100 has four keys as can be seen in Table 5-3 below.
Table 5-3 Key functions
PIN Entry Enter the security PIN to view or edit the selected parameter
Binary value display
A binary parameter
(Bit 3 is shown as active in example)
Drive Display Text Detail
Bit 12345670
Setting button - Used to navigate through the drive parameter settings and rotate displayed parameters when the drive is
running.
STOP / RESET button - Used to reset the drive if there is an error or to stop the drive running if the Run / Stop
configuration is set appropriately.
UP & DOWN buttons - Individually used to increase or decrease editable values shown on the drive display. Holding down
a button will scroll between menus or move the cursor if editing a parameter.
UP & DOWN buttons - If pressed together, they provide the drive with a run signal if the Run / Stop configuration is set
appropriately.