Nidec Control Techniques Digitax-SF DA28C23 - Page 269


Digitax SF Instruction Manual
6. Operation
5. Position Control Mode
Procedure for Press Motion
Step Operation
Step 1
Check if ready to start.


 

Step 2
Select Point No.


Step 3
Start Point Table Motion


Step 4
Check command execution
  
Step 5
Verity the start Point No.



Step 6
Check Torque Limit Status

Step 7
Clear Position Error Counter

  Position Error           

Step 8
Check if ready to start.

Step 9
Select Point No.

Step 10
Start Point Table Motion


Step 11
Check command execution
  
Step 12
Check Operation Complete

