171
n
❚❚ “Clean At”
1 Select Clean at.
Display the Clean image sensor menu as
described in Step 2 on the previous page.
Highlight Clean at and press 2.
2 Select an option.
Highlight one of the following options and press
J.
Option Description
5 Startup
The image sensor is automatically cleaned each time the
camera is turned on.
6 Shutdown
The image sensor is automatically cleaned during shutdown
each time the camera is turned off.
7
Startup &
shutdown
The image sensor is cleaned automatically at startup and at
shutdown.
8 Cleaning off Automatic image sensor cleaning off.
D Image Sensor Cleaning
Using camera controls interrupts image sensor cleaning.
Image sensor cleaning may not be
performed at startup if the flash is charging.
Cleaning is performed by vibrating the low-pass filter.
If dust can not be fully removed using
the options in the Clean image sensor menu, clean the image sensor manually (0 172) or
consult a Nikon-authorized service representative.
If image sensor cleaning is performed several times in succession, image sensor cleaning
may be temporarily disabled to protect the camera’s internal circuitry.
Cleaning can be
performed again after a short wait.
To Next Page
Loading...
