1063
Other Compatible Accessories
●
Wireless Transmitters
1, 2
WT-6 Wireless Transmitters: Use a wireless transmitter to upload
pictures over a wireless network or control the camera from a computer
running Camera Control Pro 2 (available separately). You can also take
and browse pictures remotely from a computer or smart device.
1 Requires a wireless network and some basic network knowledge. Be
sure to update the wireless transmitter software to the latest version.
2 WT-5 wireless transmitters cannot be used.
●
Wireless Remote Controllers
•
WR-R10/WR-T10 Wireless Remote Controllers: When a WR-R10 is
connected to the ten-pin remote terminal using a WR-A10 adapter, the
camera can be controlled remotely using a WR-T10 wireless remote
controller.
- The WR-R10 can also be used to control radio-controlled flash units.
- For synchronized release involving more than one camera, ready
multiple cameras with paired WR-R10 units attached.
•
WR-1 Wireless Remote Controller: WR-1 units are used with WR-R10 or
WR-T10 wireless remote controllers or with other WR-1 remote
controllers, with the WR-1 units functioning as either transmitters or
receivers. When a WR-R10 or a WR-1 configured as a receiver is
connected to the ten-pin remote terminal, a WR-T10 or a second WR-1
configured as a transmitter can be used to take pictures remotely.
Camera settings can also be adjusted using a WR-1 configured as a
transmitter.
* Be sure the firmware for the WR-R10 and WR-1 has been updated to the
latest versions (WR-R10 firmware version 3.0 or later and WR-1 firmware
version 1.0.1 or later). For information on firmware updates, see the
Nikon website for your area. Consult a Nikon-authorized service
representative when updating the firmware for the WR-R10 from
versions prior to version 2.0 to version 3.0 or later.
To Next Page
Loading...
