383
Using Non-CPU Lenses (Non-CPU Lens Data)
Recalling Non-CPU Lens Data
1
Assign [Choose non-CPU lens number] to a control
using Custom Setting f3 [Custom controls].
2
Hold the control to which
[Choose non-CPU lens
number] has been assigned
and rotate a command dial.
The selected lens number is displayed in the
top control panel. Rotate the dial until the desired lens
number is displayed.
A
Zoom Lenses
Lens data are not adjusted when non-CPU lenses are zoomed in or out.
Edit lens data after adjusting zoom.
1
Focal length
2
Maximum aperture
3
Lens number
To Next Page
Loading...
