Nikon D6 - Page 578

526
Creating a Network Profile (Ethernet)
6
Obtain or select an IP address.
•
Highlight one of the following
options and press
J
.
•
Press
J
to proceed when the “configuration complete”
message is displayed.
Option Description
[Obtain
automatically]
Select this option if the network is configured to
supply the IP address automatically. A
“configuration complete” message will be
displayed once an IP address has been assigned.
[Enter
manually]
Enter the IP address and sub-net mask manually.
•
Press the center of the multi selector to display
a dialog where you can manually enter an IP
address.
•
Rotate the main command dial to highlight
segments.
•
Press
4
or
2
to change the highlighted
segment and press the center of the multi
selector to save changes.
•
Next, press
J
; a “configuration complete”
message will be displayed. Press
J
again to
display the sub-net mask.
•
Press
1
or
3
to edit the sub-net mask and
press
J
; a “configuration complete” message
will be displayed.