688
Optical AWL
•
Choose the channel.
-For [Channel], choose the channel
(1–4) the master flash will use for
optical remote flash control.
- If the remote flash units include an
SB-500, you must choose channel
[3].
4
f
: Choose a channel for the remote flash units.
Set the remote flash units to the channel selected for
[Channel] in Step 3.
5
f
: Group the remote flash units.
•
Choose a group (A, B, or C).
•
There is no limit on the number of remote flash units that
may be used. The practical maximum, however, is three per
group, as the light emitted by the remote flash units will
interfere with performance if more flash units are used.
To Next Page
Loading...
