- D ・ -
logo_Q0650_forGraphic
071004_Gdesign_ito
VBA21001-R.3753.A
#5735
Bottom cover
#5674×2
#5735
#5674
#5674
#5735×2
#5674
Power-wire lid
・
Take out the four screws (#5735)
and ve screws (#5674).
・
Open the power-wire lid.Open the power-wire lid.
・
Remove the bottom cover.
Disassembly
1. Separation of Front and Rear Bodies
Bottom Cover
・
Take out the four screws (#6690) and two screws (#5618).
・
Remove the rear cover.
・
Remove the rear FPC from the connector.
Rear cover
Note: Remove the rear cover slowly so as not to cut the rear FPC
of the lower portion of the cover.
#5618×2
Rear FPC
#6690×4
Rear cover