Nikon D60 - Necessary Adjustments When Parts Are Replaced; D60 Adjustment Items and Firmware Updates

- Ａ  ･ -
logo_Q0650_forGraphic
071004_Gdesign_ito
VBA21001-R.3753.A
1. D60 adjustment items and Firmware updates
Adjustments
Replacement parts
Writing of
EEPROM
xed
values
AE CCD
positioning
adjustment
AE
accuracy
inspection &
adjustment
Aperture
accuracy
inspection
Battery
check volt-
age level
adjustment
Built-in SB
light volume
inspection &
adjustment
AF
accuracy
inspection &
adjustment
Eye sensor
inspection
and adjust-
ment
Shutter unit
TOGO PCB unit
（
MAIN&RISC
Firmware,register)
○ △ ○ ○ ○ ○ ○ ○
LOFT PCB
(Sub MCU mounted)
○
Relay-PCB
（
EEPROM
）
○ △ ○ ○ ○ ○ ○ ○
AF sensor unit
○
Top cover or
SB lower case unit
○
DC/DC PCB
○ ○
AE FPC unit
○ ○
Aperture control
PCB unit
○
Eye sensor FPC
○
Rear FPC
○
＊
1. Make inspection.
＊
2.
・
When only TOGO PCB unit is replaced, be sure to update the MAIN&RISC rmware.
・
When both TOGO PCB and relay-PCB are replaced at the same time, write the xed values and update the MAIN
&RISC rmware. Then, write the xed values again and make adjustment.
Caution: If the MAIN rmware named (A60******.bin) is not recognized, change the rmware name to
(A650******.bin), and update again.
If the RISC rmware named (B60****.BIN) is not recognized, change the rmware name to
(B650****.BIN), and update again.
＊ 
＊ 
＊ 
＊ 
Necessary adjustments when parts are replaced
INC