Nikon D60 - Shooting Image Adjustment Items and Firmware Updates

- Ａ  ･ -
logo_Q0650_forGraphic
071004_Gdesign_ito
VBA21001-R.3753.A
2. Shooting image adjustment items and Firmware updates
Adjustments
Replacement
parts
Serial
no.input
Writing
of xed
values
Gr/Gb
difference
compen-
sation
ADJ (G
lter)
Sensi-
tivity
Shading
Gr/Gb
com-
pensa-
tion adj.
(R/B
lter)
Sensi-
tivity
ratio
Image
shut-
ter
adjust
-ment
Pixel
defect
com-
pensa-
tion -
Black
point
Pixel
defect
compen-
sation -
White
point
TFT
adjust
-ment
Fac-
tory
de-
fault
set-
ting
Ver.
No/
Ser.
No
Shutter unit
○
AF sensor unit
DC/DC PCB unit
AE FPC unit
TOGO PCB unit
（
MAIN&RISC Firmware,
register
)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
LOFT PCB
Relay PCB
（
EEPROM
）
○
CCD/FPC PCB unit
○ ○ ○ ○ ○ ○ ○ ○
TFT monitor
○
License sheet
○
＊
1. When TOGO-PCB is adjusted, the xed values are written automatically.
＊
2.
・
When only TOGO PCB unit is replaced, be sure to update the MAIN&RISC rmware before writing the xed
values.
・
When both TOGO PCB and relay-PCB are replaced at the same time, write the xed values and update the MAIN
&RISC rmware. Then, write the xed values again and make an adjustment.
Caution: If the MAIN rmware named (A60******.bin) is not recognized, change the rmware name to
(A650******.bin), and update again.
If the RISC rmware named (B60****.BIN) is not recognized, change the rmware name to
(B650****.BIN), and update again.
＊ 
＊ 
INC