Nikon D60 - Inspection and Adjustment of Body Back

- Ａ  ･ -
logo_Q0650_forGraphic
071004_Gdesign_ito
VBA21001-R.3753.A
Measuring point
Surface plate
0
0" position of D60
0
0
0
0
0
0
0
0
0
0
0
Inspection and Adjustment of Body back
＊ "0" positioning of the dial gauge
・
Measure three parts from the bayonet face to the CCD-
PCB attaching face.
Standard:48.59±0.015mm/ Parallelism: 0.015mm or less
・In case it is out of standard, make adjustment
by loosening screws that attach the front and rear bodies,
or by putting the washer(s) on the contact surface
between the front body and rear body.
①
Put the tool (J18001-1) on the surface plate, and set the dial gauge to "0".
②
Turn the index ring in the direction of the arrow from the above "0", and set the scale to "8
"
. (This is
"0"-position of D60.)
③
Measure the body back, based on "0" reference position of the index ring.
Note: For some bodies, washer(s) or tracing-lm sheet are already put on the attaching face of the CCD-bracket.
There are three cases as follows.
1. Purpose
：
To adjust the height of the camera body
There are indications by color marker on the CCD-PCB attaching face of the camera body side .
{Blue =0.02mm (#87), Red
＝
0.01mm (#88), Green
＝
0.06mm (#89)}
＊
By adding the measured value to the thickness of washers, check if it is within the standard (48.59±0.015mm).
2. Purpose
：
To adjust the height of the CCD bracket
There are indications by marker on the CCD-bracket attaching face
One marking
＝
Put three washers [#88 (0.02mm)] at three places
Two markings
＝
Put three washers [#87 (0.1mm)] at three places
＊
When the CCD PCB is replaced, remove the washers.
3.Any marking(s) of the three in the right "Fig.
①
"
＝
Put the tracing-lm sheet (#84) in the marked place(s).
＊
When the CCD PCB is replaced, remove the tracing-lm sheet.
Marking
Fig.
①
INC