87
❚❚ Camera Controls
1 Assign image area selection to a camera control.
Use Custom Setting f1 (Custom control assignment, 0 268)
to assign Choose image area to a control.
2 Use the selected control to choose an image area.
The image area can be selected by pressing the selected
control and rotating the main or sub-command dial until the
desired crop is displayed in the viewfinder (0 85).
The option currently selected for
image area can be viewed by
pressing the control to display the
image area in the control panel or
information display. FX format is
displayed as “36 - 24”, 1.2 × as
“30 - 20”, DX format as “24 - 16”, 5 : 4
as “30 - 24”, and 1 : 1 as “24 - 24”.
A See Also
For information on:
• The crops available for movie recording, see “Image Area: Choosing a
Movie Crop” (0 68).
• The number of pictures that can be stored at different image area
settings, see “Memory Card Capacity” (0 362).
To Next Page
Loading...
