Chapter 4 Assembly
79
4.5.2 Cable connection for the manual revolving nosepiece and the MA200
Connect the cable of the revolving nosepiece to the connector on the microscope.
1 Loosen the rear-panel clamp screw on the
microscope with the supplied hexagonal
screwdriver to remove the rear-panel.
2 Connect the cable of the revolving nosepiece to
the connector on the microscope.
Connect the cable of the MA2-NUI5 revolving
nosepiece to the round connector on the
microscope.
Connect the cable of the D-ND6/D-NI7 revolving
nosepiece to the square connector.
3 Secure the clamp screw to reattach the
rear-panel.
* The address information for the revolving nosepiece is displayed on the MA200 front display via cable
connection. Additionally, the address information can be output to a device including a PC or the DS-L2 via
USB connection.
4.5.3 Connecting the motorized nosepiece and the Nosepiece Controller 2
Make sure to turn off the motorized Nosepiece Controller 2 to attach or remove the signal cable.
1 Loosen the rear-panel clamp screw on the
microscope with the supplied hexagonal
screwdriver to remove the rear-panel.
2 Remove the cap from the signal cable hole on the
rear-panel.
3 Pass the signal cable for the LV-NCNT2
Nosepiece Controller 2 through the hole of the
rear-panel, then connect it to the cable of the
revolving nosepiece.
4 Secure the clamp screw to reattach the
rear-panel.
5 Connect the signal cable to the motorized
nosepiece connector on the LV-NCNT2.
6 Connect the LV-NCNT2 to the [NCNT] connector
on the MA200 main body using the RS232C cross
cable.
Round connector
Square connector
To Next Page
Loading...
