Chapter 4 Assembly
83
4.12 Various Sliders for Attaching the Revolving Nosepiece
To insert a slider, be sure to attach the objective in advance.
4.12.1 L-DIC/L-DIHC slider (single NR method)
For using the DIC slider in single NR method, attach the MA2-NUI5 revolving nosepiece or LV-NU5A
motorized nosepiece.
1 Loosen the DIC slider limit screw on the
nosepiece using a hexagonal screwdriver.
2 Remove the slot from the revolving nosepiece to
insert the DIC slider.
3 Screw in the DIC slider limit screw.
When removing the DIC slider from the nosepiece,
fully loosen the DIC slider limit screw using a
hexagon screwdriver, and then pull out the slider.
Sliding limit groove
Prism setting dial
Prism movement knob
DIC slider limit screw
Quintuple nosepiece
To Next Page
Loading...
