Chapter 4 Assembly
95
■ Attaching the DS-L2
1 Remove the one-touch release attached to the
front of the mount arm for the supporting arm.
Pull up the mount arm attaching/detaching knob,
then hold up the docking section forward to
remove it.
2 Detach the stand arm attached on the rear of the
DS-L2 by removing the four clamp screws.
3 Fix the docking section of the one-touch release to
the rear of the DS-L2 by using the clamp screws
(4) removed in Step 2.
4 Insert the docking section into the upper
one-touch release. Align the pins on the mount
arm with the holes on the docking section to insert
it.
The DS-L2 attached to the supporting arm can be
removed by pulling up the mount arm
attaching/detaching knob.
6 The rotation torque can be adjusted depending on
the tightness of the docking section of the mount
arm to keep the DS-L2 steady, while achieving
more comfortable operation for angle adjustment.
Turn the two nuts on the docking sections with the
supplied tool and control each rotation torque for
the horizontal/vertical direction.
■ Cable connection between the DS-L2 and MA200
1 Connect the DS camera attached to MA200 with
the Camera connector on the left-side of the
DS-L2 using the camera cable exclusive for the
DS camera.
2 Connect the USB (H) connector on the right-side
of the DS-L2 and the [USB] connector on the rear
of the MA200 main body using the USB cable.
3 Connect the AC adapter exclusive for the DS-L2 to
the 12 VDC IN connector on the left side of the
DS-L2.
Mount arm
attaching/detaching knob
One-touch
release
Rotation torque
nuts (x2)
Docking
section
(both sides)
Supporting arm
(1)
(2)
(2)
(3)
To Next Page
Loading...
