10
OPERATING GUIDE
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER!
WARNING!
CAUTION!
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do
not cover these plates for any reason and immediately replace them if damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either
improperly installed or connected. The batteries must be installed by qualified personnel. Set
the battery charger (optional) and machine PCBA according to the battery type (WET or GEL
or AGM or
DIS-EV
). Check the batteries whether it is damaged before installation. Disconnect
the battery connector and the battery charger plug. Handle the batteries with great care.
The machine requires two 12V batteries or four 6V batteries, connecting according to Figure3.
The machine can be operated in one of following battery modes:
A) (WET OR GEL OR AGM OR DIS-EV) batteries are already installed and ready to be used
1. Check the batteries and connect the battery connector to the machine.
2. Insert the ignition key (24) and turn it on. If the LED screen (29) shows battery level is 100% power remaining,
cleaning work can be started; if only 10% battery power remaining, charge the batteries first.
B) Without Batteries
1. If your machine isn’t equipped with batteries, buy appropriate batteries [See the Technical Data Paragraph]. For
battery choice and installation, turn to qualified battery Retailers.
2. When batteries are ready, set the machine and the battery charger according to the type of installed batteries,
then follow the procedures shown in the next paragraph.
To Next Page
Loading...
