21
SQUEEGEE CLEANING
NOTE
The squeegee must be clean and its blades must
be in good conditions in order to get good
drying.
CAUTION
It is advisable to wear protective gloves when
cleaning the squeegee because there may be
sharp debris.
1. Drive the machine on a level floor.
2. Turn the ignition key (A, Figure 22) to “I”.
3. Press vacuum system switch (C Figure 21) to release
squeegee(G, Figure 21).
4. Loosen the knobs (F Figure 21) and remove the squeegee.
5. Disconnect the vacuum hose (E Figure 21) from the
squeegee.
6. Clean the steel or the aluminum squeegee (Figure 21). Clean
the compartments (A) and the hole (B) especially. Check the
front blade (C) and the rear blade (D) for integrity, cuts and
tears; if necessary replace them (see the procedure in the
following paragraph).
7. Assemble the squeegee in the reverse order of disassembly.
8. After clean the squeegee, carefully lift the recovery tank lid
(D Figure 22), take the squeegee hung in recovery tank’s
grooves (B Figure 22), so that the recovery tank has been
ventilated and the machine through the narrow passage easy.
D
A
C
100%
AGM
B
F
G
F
E
A
A
D
C
B
To Next Page
Loading...
Need help?
General
