General Information 30Service Manual – SC6500
™
PM Check List - SC6500
Customer _________________________________________________________
Address ___________________________________________________________
City ____________________________ ST _______________ Zip____________
Model _____________ Serial ______________________ Hours _____________
Defect Code
A needs adjustment
B binding
C dirty or contaminated
D damaged, bent or torn
L leaks
M missing
W worn out
Ref Operational Inspection Items OK Defect Codes
(Circle)
Does
Not
Work
1 Steering A B W
2 Drive Pedal Operation (check for Fwd/Rev drive and any
neutral creep)
A B D
3 Seat Safety Switch (when operator stands up machine is to
stop)
A D
4 Brakes (service and parking) A B W
5 Drive System Performance (reference Service Manual for
Curtis drive programmer speed changes)
noisy sluggish
6 Scrub System (Raise/Lower and auto scrubbing functions) A B
7 Scrub Brush Pressure Settings (see Service Manual
programming, 3 different modes)
A B
8 Squeegee System (Raise/Lower and auto lift in reverse
function)
A B
9 Vacuum Performance (sealed water lift 70” and 1-inch open
hole adapter 15 inches)
C L W
10 Solution Control (On/Off and ow volume Min/Max) A B L
11 Solution Control (On/Off and ow volume Min/Max) B D
12 Emergency Battery Disconnect Control Lever A B D
13 Side broom Sweep System, Raise/Lower and auto sweep
functions (cylindrical only)
A B D
14 Tilt Steering Mechanism and Seat D
15 Main Control Board Special Program Options (check all
applicable program settings); Example, Fault Recall Mode,
etc.
Program as needed
16 Battery Charger Operation D
17 Chemical Detergent System Functions C L
To Next Page
Loading...
