Nilfisk-Advance SC6500 45C User Manual

General Information 27Service Manual – SC6500
™
Circuit Breakers
The machine circuit breakers are located on the panel to
the left of the Operator seat.
General Maintenance
Maintenance After Use
1. When nished scrubbing, press the Scrub Off Switch. This will automatically raise the scrub deck and
squeegee, and switch off the solution, detergent and vacuum systems.
2. Drive the machine to a service area for daily maintenance, and check the machine for any additional
maintenance or service that may be needed.
3. To empty and clean the solution tank:
a. Remove the Solution Tank Drain
Hose
from its storage clamp.
b. Direct the Solution Tank Drain Hose
to a designated disposal site and
remove the Solution Tank Drain
Hose Plug
.
c. Rinse the tank with clean water.
4. To empty and clean the recovery tank:
a. Pull the Recovery Tank Drain Hose
from its storage area.
b. Direct the Recovery Tank Drain
Hose
to a designated disposal site
and remove the Recovery Tank
Drain Hose Plug
. (Hold the end of
the Recovery Tank Drain Hose above
the water level in the tank to avoid
sudden, uncontrolled wastewater
ow.) The Recovery Tank Drain Hose
can be squeezed to regulate the
ow.
c. Rinse the recovery tank with clean
water.
Solution Tank
Drain Hose
Solution Tank
Drain Hose Plug
Recovery Tank
Drain Hose
Recovery Tank
Drain Hose Plug
Vacuum
Hose
Hopper

Nilfisk-Advance SC6500 45C Specifications

General

Brand	Nilfisk-Advance
Model	SC6500 45C
Category	Scrubber
Language	English