INSTRUCTIONS FOR USE ENGLISH
14 664 7 2000 - S W 5 5 00, F L O O R T E C R 9 8 5 21
03/2016
MACHINE OPERATION
1. rive the machine to the work area as shown in the previous paragraph.
2. S t a r t cl e a n i n g b y l o w e r i n g t h e m a i n b r o o m a n d a ct i va t i n g t h e va cu u m syst e m w i t h t h e O n e - T o u ch p u sh - b u t t o n ( 5 2) .
3. ( O p t i o n a l ) a ct i va t e t h e D u st G u a r d ™ syst e m w i t h t h e co r r e sp o n d i n g p u sh - b u t t o n ( 68 ) .
4 . L o w e r t h e si d e b r o o m s w i t h t h e p u sh - b u t t o n s ( 5 3) a n d ( 5 4 , o p t i o n a l ) . I f n e ce ssa r y , a d j u st t h e sp e e d o f t h e si d e b r o o m s w i t h t h e
+ a n d - p u sh - b u t t o n s ( 5 5 , i co n o n d i sp l a y 7 1- I ) .
N O T E
The brooms (18, 15 and 16) can be lowered and lifted even when the machine is moving.
When the brooms are lowered, the brooms, the vacuum system and the dust guard system (optional) automatically
activate only when the machine is moving.
N O T E
The side broom icons (71-F) keep the operator informed of the working conguration of the side brooms. When the icon
is present, the corresponding side broom is activated and deactivated together with the main broom via the One-Touch
push-button (52).
5 . S t a r t sw e e p i n g b y d r i vi n g t h e m a ch i n e w i t h t h e h a n d s o n t h e st e e r i n g w h e e l ( 1) a n d b y p r e ssi n g t h e a cce l e r a t o r p e d a l ( 5 ) . I f
n e ce ssa r y , se t t h e m a xi m u m sp e e d w i t h t h e p u sh - b u t t o n s ( 5 8 ) a n d ( 5 9 ) .
6. rive the machine straight forward at a uick walking speed. rive the machine slower when sweeping large amounts of dust
o r d e b r i s o r w h e n sa f e o p e r a t i o n d i ct a t e s sl o w e r sp e e d s. O ve r l a p p a sse s 10 cm .
7 . To collect light and ulk waste materials, lift the front skirt pressing the pedal (8) take into consideration that the machine
vacuum capailit is reduced when the front skirt is lifted.
WARNING!
When operating on wet oors, it is essential to turn off the vacuum system by pressing the push-button (56) to
prevent the dust lter from being damaged.
8 . For machine proper operation, the dust filter must e as clean as possile. To clean it while sweeping, operate the filter shaker
b y p r e ssi n g t h e p u sh - b u t t o n ( 5 7 ) .
hile working, repeat the procedure ever 10 minutes on average (depending on the dustiness of the area to e cleaned).
N O T E
This procedure can also be performed when the machine is moving.
CAUTION!
When the dust lter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore.
9 . The hopper (12) should e dumped after each working period and whenever it is full (see the procedure in the next paragraph).
CAUTION!
The engine is equipped with a warning system to prevent damages to the engine itself in case the oil quantity in
the carter is insufcient. Before the oil level goes below the safety limit, the warning system automatically stops
the engine and displays the icon (71-R) on the multifunction display.
CAUTION!
In the event of an overload of one of the broom motors, due to foreign bodies blocking it or excessive pressure
of the broom on the ground (see procedure in the Main/Side Broom Height Check and Adjustment paragraph of
the Maintenance chapter), a safety system stops the motor.