Nilfisk-ALTO SCRUBTEC R 466 Service Manual

Scrub System, Disc 78Service Manual – SCRUBTEC R466 ... FOCUS II Micro Rider
Maintenance and Adjustments
Brush/pad-holder installation/removal
1. Insert the ignition key and turn it to “I”.
Warning! Before pressing the scrub On/Off push button , always check that, between the
deck and the machine there is no foreign material which may prevent the deck from
lifting.
2. Lift the deck by pressing the scrub On/Off push button .
3. Turn the ignition key to “0”.
4. Manually move the deck assembly to the left, then release the lever (D) and disassemble the covers (E)
and (F) from the deck.
5. Install the brushes/pad-holders on the deck drive hub (G) by pushing them upwards until they are
engaged.
6. To remove the brushes/pad-holders perform steps 1 to 3, then release them from the hub by pushing
rmly downwards.
Warning! If the machine is not perfectly assembled it can cause damages to people and
properties. Always check that all components are assembled before starting the
machine. Carefully inspect the machine before using it.
A
G
A
E
F
D
B
C
B
C
Front
P100730

Nilfisk-ALTO SCRUBTEC R 466 Specifications

General

Brand	Nilfisk-ALTO
Model	SCRUBTEC R 466
Category	Scrubber
Language	English