Nixeus NX-EDG34S User Manual

43
Other – DP Version
DP version allows you to apply the DisplayPort version to use with the monitor.
a) In the OTHER sub-menu, use the buttons ∇ or ∆ to highlight DP Version and press [1] to confirm selection.
b) Press ∇ or ∆ to adjust the DisplayPort (DP) Version to your desired setting. The version can be set in 1.1,
1.2, and 1.4 modes.
c) Once you finish adjusting the DP Version settings to your desired setting, press [1] once to confirm and exit
to the OTHER sub-menu.
d) Press [2] once to exit out of OTHER sub-menu and again to close the OSD menu.
Note: For native 3440 x 1440 resolutions with native 144Hz refresh rate, the DP Version must be set to DP 1.4.
You also need a DisplayPort cable, hardware or source device with DisplayPort 1.4 features.

Nixeus NX-EDG34S Specifications

General

Brand	Nixeus
Model	NX-EDG34S
Category	Monitor
Language	English