Nixeus NX-EDG34S User Manual

8
Stand Installation
1) Open the package, take out the product with foam still attached, and gently place it on a desktop or
table.
2) Remove the extra parts and the foam covering the back of the monitor. Then press the button to remove the stand plate.
3) Use the screwdriver and three screws to fasten the base to the stem. Next use two screws to fasten the stand plate to the
stem.
4) Insert the stand's plate into the opening on the back of the
monitor. It
should click
into place. Make
sure the stand
is
securely
attached to the back of the monitor then remove
the
monitor from the remaining foam section and stand
it
up on a table or desk as
desired.
If needed, the stand can easily be
detache d
from the monitor by
pressing
the button
near
the stand plate. Make sure the monitor is laid on
a
flat surface before removing the
stem.

Nixeus NX-EDG34S Specifications

General

Brand	Nixeus
Model	NX-EDG34S
Category	Monitor
Language	English