Nokia WiFi Beacon 6 Product Guide Configure a Beacon 6 (HA-0336W-B)
Issue: 01 3FE-47429-AAAA-TCZZA 87
Figure 33 QoS Config window (L2)
Table 28 describes the fields in the QoS Config window.
Table 28 QoS Config parameters
Field Description
Type Choose a QoS service layer type from the drop-down menu, either L2 or L3
Source MAC Enter the source MAC
Select the Exclude checkbox to exclude the source MAC
Interface Choose an interface from the drop-down menu
Classification row
DSCP Remark Enter the value for the DSCP remark (range: 0-63). This field is read-only for L2
criteria. For L3 criteria, read and write access is available.
802.1p Remark Enter the value for the 802.1p (range: 0-7)
Forwarding Policy Enter the number for the forwarding policy (range: 1-7)
Additional fields for L3
Protocol Choose a protocol from the drop-down menu, or select the Exclude checkbox
Application Choose an application from the drop-down menu
Source IP and
Source IP Mask
Enter the values for the source IP and IP mask, or select the Exclude checkbox
Destination IP and
Destination IP Mask
Enter the values for the destination IP and IP mask, or select the Exclude checkbox
To Next Page
Loading...
