Nokia PremiCell - ATP Set Pulse Dial as Default; ATT Set Tone Dial as Default; AT+CHUP Hang up Call; AT+CRC Cellular Result Codes

ã2000 Nokia Mobile Phones. All Rights Reserved. 13
ATP Set Pulse Dial as Default
This command has no effect on the data adapter. It is included for
compatibility rea-
sons. Syntax: ATP
ATT Set Tone Dial as Default
This command has no effect on the data adapter. It is included for
compatibility rea-
sons. Syntax:
ATT
AT+CHUP Hang Up Call
This command hangs up the call, also when an alternating mode call
is ac-
tive.
Syntax:
AT+CHUP Hang up call. Response is NO CARRIER.
AT+CRC Cellular Result Codes
This command controls whether or not the extended format incom-
ing call indication is used. When enabled, an incoming call is indi-
cated to the DTE with the result[“resulting”?] code +CRING:<type>
i n s t e a d o f t h e n o r m a l R I N G .
Syntax:
AT+CRC=[<mode>] Set incoming call indication mode.
AT+CRC? Query current setting. Response is
+CRC:<n>.
AT+CRC=? Show supported modes. Response is
+CRC:(list of supported <mode>s).
Values for <mode>:
0 Disable extended format call indica-
tion.
1 Enable extended format call indication.