Nokia PremiCell - CDS Received Status Report Routing

ã2000 Nokia Mobile Phones. All Rights Reserved. 63
<pid> protocol identifier in integer format
<dcs> SMS Data Coding Scheme
<sca> service centre address
<typesca> type of service centre address, 129 for normal and 145
for
international access (number contains ‘+’ character)
4.7 +CDS Received Status Report Routing
This response is used to carry a received short message status report
to the DTE when direct routing has been activated with the AT+CN-
MI
command. The response +CDS:<length><CR><LF><pdu> is used
when PDU mode is enabled, and +CDS: <fo>,<mr>,[<addr>],
[<type>], <scts>,<dt>,<st> when text mode is used.
<length> length of the actual PDU in octets
<pdu> service centre address followed by GSM 03.40 Protocol
Data Unit in hexadecimal format
<fo> first octet of SMS-STATUS-REPORT in integer format
<mr> message reference
<addr> receiver address
<type> type of receiver address, 129 for normal and 145 for
international access (number contains ‘+’ character)
<scts> service centre time stamp
<dt> discharge time
<st> status