Nokia PremiCell - AT+ICF DTE-DCE Character Framing

ã2000 Nokia Mobile Phones. All Rights Reserved. 27
AT+ICF DTE-DCE Character Framing
This command is used to determine the character framing that the
data adapter uses while accepting commands and while transmit-
ting
information text and a result code to/from a DTE.
Note: The terminal does not support autobauding. Therefore, after
changing character framing settings of the data adapter and your
communications application, close and restart the communications
application. For repeated use of these settings you should issue the
AT-commands AT&W and AT&Y.
Syntax:
AT+ICF=[<format>[,<parity>]] Set character framing.
AT+ICF? Query current setting.
Response is +ICF:<format>,<parity>.
AT+ICF=? Show valid range of parameters.
Response is +ICF:(1-6), (0,1,4).
Parameters:
<format>
3 8 data, no parity, 1 stop
4 7 data, no parity, 2 stop
5 7 data, parity, 1 stop
6 7 data, no parity, 1 stop
<parity>
0 odd
1 even
4none