ã2000 Nokia Mobile Phones. All Rights Reserved. 59
4. Special Responses in AT Command Mode
4.1 +CME ERROR Mobile Equipment Error Result Code
The operation of the +CME ERROR: <err> result code is similar to
the
regular ERROR result code. If +CME ERROR: <err> is the result code
for any of the commands in a command line, none of the following
commands in the same command line are executed. Neither the ER-
ROR nor the OK result code will be returned as a result of a com-
pleted
command line execution. The format can be either numeric or ver-
bose. This is set with the command +CMEE.
<err> values (numeric format followed by verbose format):
0 terminal failure
1 no connection to terminal
2 terminal-adapter link reserved
3 operation not allowed
4 operation not supported
10 SIM not inserted
S45 Radio Link Protocol N2 repetition count (1-255). 6
S46 Force Data Compression
(only for mobile to mobile connections)
0=Disabled
1=Data compression in transmit direction only
2=Data compression in receive direction only
3=Data compression in both directions
0
S47 Error Correction Mode with FClasses 2 and 2.0
0=Disabled
1=Enabled, 64 byte frames
2=Enabled, 256 byte frames
0
S-Reg Unless otherwise specified the value range
Default
of the settings is from 0 to 255
To Next Page
Loading...
