Nokia PremiCell - AT+COLP Connected Line Identification Presentation

30 ã2000 Nokia Mobile Phones. All Rights Reserved.
0 disable CLIP
1 enable CLIP
CLIP information:
When the presentation of the CLIP on the DTE is enabled (and the
calling subscriber permits), the +CLIP:<number>,<type>[,,,<al-
pha>] response is returned after every RING result code sent from
the data adapter to the DTE (or +CRING).
<number> phone number
<type> type of number, 129 for normal and 145 for internation-
al
access (number contains ‘+’ character)
<alpha> optional alphanumeric representation of a <number>
corresponding to the entry found in the data adapter
phone
book
AT+COLP Connected Line Identification Presentation
This command refers to the GSM supplementary service COLP (Con-
nected Line Identification Presentation) that enables a calling sub-
scriber to
obtain the connected line identity (COL) of the called party after
setting up a mobile originated call. The command enables or disa-
b l e s t h e p r e s e n t a t i o n o f t h e C O L a t t h e D T E .
Syntax:
AT+COLP=[<mode>]
Set COLP mode.
AT+COLP? Query current setting. Response is
+COLP:<mode>,2.
AT+COLP=? Show supported modes.
Response is +COLP: (list of supported <mode>s).
Values for <mode>:
0 disable COLP
1 enable COLP