• Ahne RF ASIC (application specific integrated circuit)
• Front end module (FEM) module (Power amplifier and Antenna switch)
The RF engine also includes:
• Voltage controlled oscillators (VCO and VCTCXO)
• SAW filters
The baseband section controls the RF module through the serial bus, RFBus. This passes information about
eg. frequency band and mode of operation. Ahne RF ASIC controls the mode of operation, and further sends
control signals to the front end module.
In addition to the RFBus there are other interface signals for the power control loop, VCTCXO control and for
the modulated waveforms.
Main processor
The main processor in this device is RAPGSM, a BB5.0 ASIC.
Some of its interfaces, processors and controllers are:
• General purpose UARTs
• Processor modules
• I2C (between ICs) interface
• GSM coder
• Interfaces to user interface, SIM and MMC
• Accessory interface
• Handling of RF-BB interface
• I/O voltage = 1.8 V, Core voltage <1.8 V
Energy management
Two ASICs manages the energy in the phone; Retu and Tahvo. Together they cover the analogue audio and
energy management function needs.
Tahvo
All blocks that need a special silicon process are included in Tahvo.
Tahvos main features are:
• Energy management control
• Supply voltage generation
• Charge control
• Digital core supply
• Current control for LED supply
Retu
The blocks that do not have special needs are included in Retu.
Retu controls for example:
• Audio block
• SIM
• FM radio
RM-70
System module Nokia Customer Care
Issue 1 COMPANY CONFIDENTIAL Page 8 –9
Copyright © 2005 Nokia. All rights reserved.
To Next Page
Loading...
Need help?
General
