nord NORDAC PRO SK 511E Series - Motor Data

SK 54xE – Users Manual for Frequency Inverters
102 BU 0505 EN-3021
Information
Option monitoring P120
Optional monitoring (P120) is only function for option modules which are connected via the system bus (e.g. I/O
extensions).
This parameter can not be used for TU3 modules. In this case, monitoring via parameter P513 is possible.
Pos: 147 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ P2xx Motordaten / Kennli nienparameter @ 0\ mod_1327588046860_388.d ocx @ 7838 @ 5 @ 1
Motor data / Characteristic curve parameters
Parameter
{factory setting}
Setting value / Description / Note Supervisor Parameter set
Pos: 148 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Parameterauflis tung (P000 ...)/P200- P299/Parameter P200 – Motor liste - Allgemeiner Teil [BU0180, BU0200, BU 0500] @ 6\mod_1421165097687 _388.docx @ 198991 @ @ 1
P200
Motor list
(Motor list)
P
0 ... 73
{ 0 }
The factory settings for the motor data can be changed with this parameter. The factory setting in
parameters P201...P209 is a 4-pole IE1 - DS standard motor with the nominal FI power setting.
By selecting one of the possible digits and pressing the ENTER key, all motor parameters
(P201…P209) are adjusted to the selected standard power. The basis for the motor data is a 4-pole
DS standard motor The basis for the motor data is a 4-pole DS standard motor The motor data for
NORD IE4 motors can be found in the final section of the list.
NOTE:
As P200 returns to = 0 after the input confirmation, the control of the set motor can be implemented
via parameter P205.
Information
IE2/IE3 Motors
If IE2/IE3 motors are used, after selecting an IE1 motor (P200) the motor data in P201 to P209
must be adapted to the data on the motor type plate.
Pos: 149 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Parameterauflis tung (P000 ...)/P200- P299/Parameter P200 – Motor liste [SK 2xxE, SK 5xxE] @ 6\mod_14211653 68263_388.docx @ 199023 @ @ 1