Nordmann DC4 - Control Settings

21
In the upcoming modication dialogue select the desired signal source.
Factory setting: Analog
Options: Analog or RF Hum. (if the optional radio humidity sensor is used)
Note: if “RF Hum.” is selected as signal source (optional radio humidity sensor), the sensor symbol
is shown in the upper right corner of the standard operating display afterwards (see the most right
display above).
4.6.3.2 Selecting the control type
Select “Hum.Control” in the control settings menu, then press the <Set> key.
The control settings appear. The settings available depend on the selected signal source and the
control type. The above display shows the maximum number of settings available. Informations
regarding the individual settings can be found in the following chapters.
4.6.3.1 Selecting the signal source
Note: The setting “SignalSource“ appears only if a receiver modul for the optional radio humidity
sensor is installed in the Nordmann RC4/DC4.
Select “SignalSource” in the control settings menu, then press the <Set> key.
In the upcoming modication dialogue select the desired control type.
Factory setting: External
Options: External (external continuous controller),
24VOn/Off (external On/Off humidistat),
Int. (P) (Internal P controller)
Int. (PI) (Internal PI controller)
4.6.3 Control settings
Select “Controls” in the settings menu, then press the <Set> key.
Integr.-Time:8min
Controls
Hum.Control :Int.(PI)
Controlsign.:0-10V
Hum.Setpoint:Set
SignalSource:Analog
P-Band :18%rH
Esc Set
Settings
Controls :Set
Power Limit :100%
On/O Timer :Set
Language :English
GFCI-Mode :On
Esc Set
Lim. Control:On
Limitsignal :0-10V
Limit Min :70%rH
Limit Max :90%rH
SignalSource
Analog
RF Hum.
Analog
Esc Set
Controls
Hum.Control :Int.(PI)
Controlsign.:0-10V
Hum.Setpoint:Set
SignalSource:Analog
P-Band :18%rH
Esc Set
Settings
Controls :Set
Power Limit :100%
On/O Timer :Set
Language :English
GFCI-Mode :On
Esc Set
Hum.Control
External
24VOnO
Int.(P)
External
Int.(PI)
Esc Set
Controls
Hum.Control :Int.(PI)
Controlsign.:0-10V
Hum.Setpoint:Set
SignalSource:Analog
P-Band :18%rH
Esc Set
Settings
Controls :Set
Power Limit :100%
On/O Timer :Set
Language :English
GFCI-Mode :On
Esc Set
Demand :50%
RC4 230V2
Lim. Control:80%
2011-10-31 12.00.00
Menu Set