Leaf User Manual
P/N: 97-4000, Revision 08, Release date: 2020-11-10 Page 45 of 85
Pairing an Unpaired Tablet with Laser Console
A user interface tablet is paired with a laser console at the Norlase factory. If it becomes
necessary to pair a new tablet with a laser console please use the following procedure:
1. Obtain the Type C USB to Micro USB cable supplied with the tablet.
2. Turn on laser system. The status LED on side of laser system will be flashing blue.
3. Turn on user interface tablet.
a. The tablet will display “Create Bond”.
4. Plug one end into the Micro USB port on the bottom of the Laser Console and the other
end into the Micro USB port of the tablet.
5. Press the “Create Bond” button and observe the status LED on the laser console.
6. When the Status LED turns green the tablet has been successfully paired.
Pairing a Paired Tablet to a different Laser Console
If it becomes necessary to pair a tablet with a different laser console than it was previously paired
with, please use the following procedure:
1. Obtain the Type C USB to Micro USB cable supplied with the tablet.
2. Turn on laser system.
3. Turn on user interface tablet.
a. From the default start up screen select the “Settings” tab at the top of the screen.
b. Select the “REMOVE” toggle under the “REMOVE BOND” section.
4. Plug one end into the Micro USB port on the bottom of the Laser Console and the other
end into the Micro USB port of the tablet.
5. Press the “Create Bond” button and observe the status LED on the laser console.
6. When the Status LED turns green the tablet has been successfully paired.
To Next Page
Loading...