Leaf User Manual
P/N: 97-4000, Revision 08, Release date: 2020-11-10 Page 54 of 85
System Relocation Instructions
To move Norlase Leaf to another location:
1.
Ensure that both the wall circuit breaker and the system main power switch are
turned off.
2.
Remove the power cable from the wall outlet and the system main power receptacle.
3.
If a remote door interlock is utilized, remove the interlock plug and cable from
the interlock port and transport separately.
4.
Disconnect the footswitch cable from the footswitch port and transport
separately. Never drag the footswitch.
5.
Mount the system onto the tonometer mount of the desired slit lamp. PLEASE
NOTE: The system may be relocated to the same type or similar slit lamp. If
the slit lamp is not exactly the same as the previously mounted system there
may be subtle differences that do not allow the system to function as before.
Consult with Norlase Technical support or your authorized distributor.
6.
If there are changes in environmental conditions (temperature or humidity)
allow system to acclimate for 4 hours prior to use to prevent condensation.
Room Preparation
1.
Verify that the system power cable and plug are correctly connected, as
instructed in the preoperative instructions.
2.
Verify environmental conditions are within limits for operation.
NOTE
For systems configured with an electrical wall circuit breaker, always place the
electrical wall circuit breaker in the off position before inserting the plug into the
receptacle.
3.
Verify that the electrical service is turned on.
4.
Verify that the laser warning sign has been posted outside of the treatment room door.
5.
Ensure that all attending personnel in the treatment room are wearing appropriate
eye protection goggles or eyeglasses.
To Next Page
Loading...
