Nortel 1000E - Page 151

Installing software on the CS 1000E Page 151 of 488
Communication Server 1000E Installation and Configuration
Switch call processing
Procedure 32
Switching call processing
End of Procedure
Perform a customer backup data dump (installation release)
Procedure 33
Performing a data dump to backup the customer database:
1 Log in to the system.
2 Insert a CF card into the active Call Server RMD slot to back up the
database.
3 Load the Equipment Data Dump Program (LD 43). At the prompt, enter:
4 When “EDD000” appears on the terminal, enter:
LD 135 Load program
SCPU Switch call processing from Call Server 0
to Call Server 1
Call Server 1 is now the active call processor.
LD 43 Load program.
. EDD
EDD Begin the data dump.
CAUTION — Service Interruption
Loss of Data
If the data dump is not successful, do not continue;
contact your technical support organization. A data
dump problem must be corrected before proceeding.