Page 256 of 488 Connecting a Terminal Server
553-3041-210 Standard 4.00 September 2007
Procedure 62
Connecting a Terminal Server to the system
1 Connect the MRV P/N-151-3028 serial cable from the Terminal Server
console port 20 to the PC COM port.
2 Plug MRV PC Card (in MRV package) into Terminal Server faceplate
socket, and power on the Terminal Server.
3 Start the MRV HyperTerminal application. In Windows:
Start > Programs > Accessories > Communication >
HyperTerminal.exe
4 Configure HyperTerminal to communicate with the Terminal Server’s
management port:
3 TXD 6 RxD
4 DTR 7 DSR/DCD
5 S GND 4
5
TxD GND
RxD GND
7 RTS 1 CTS
8 CTS 8 RTS
9 N/C
WARNING
Port 20 is the default console port. Do not change the
configuration for port 20.
Table 15
Customer made cable pin out
Pins on DB9 Female Pins on RJ45 Male (MRV Terminal Server)
To Next Page
Loading...
