Nortel 1000E - Page 429

Installing and configuring IP Phones Page 429 of 488
Communication Server 1000E Installation and Configuration
6 Choose one of the following:
a. Enter 0 to configure no VLAN.
The IP Phone displays:
Locating server...
After several seconds, the IP Phone prompts:
Connect Svc
Node: x
TN: x.x
Go to step 7 on page 429.
b. Enter 1 to configure manual VLAN.
The IP Phone prompts:
VLAN: x
Go to step 7.
c. Enter 2 to configure automatic VLAN.
The IP Phone prompts:
VLAN: x
Go to step 7
7 Enter the VLAN ID.
The IP Phone displays:
Locating server...
If you did not configure an IP Phone Installer Password, after several
seconds, the IP Phone prompts:
Node: x
TN: x.x
8 Enter the node number and the IP Phone's (virtual) TN, and then go to
step 11 on page 430.
If you configured an IP Phone Installer Password, the IP Phone prompts:
Node: x
PassWord: 0