Nortel 7 - Table 10 Configuring RIP over a Secondary Address

102 Chapter 5 Configuring the system
NN46110-500
Table 10 displays the command syntax for configuring RIP
Set the OSPF priority on a secondary
address
CES(config-if)# ip ospf priority <0-255>
<secondary address>
Reset the OSPF priority on a secondary
address
CES(config-if)# no ip ospf priority <secondary
address>
Set the OSPF MD5 key on a secondary
address
CES(config-if)# ip ospf message-digest-key
<keyid> md5 <auth-key> <secondary address>
Reset the OSPF MD5 key on a
secondary address
CES(config-if)# no ip ospf message-digest-key
<secondary address>
Table 10 Configuring RIP over a secondary address
Command description Command syntax
Enable RIP on a secondary address CES(config-if)# ip rip <secondary address>
Disable RIP on a secondary address CES(config-if)# no ip rip <secondary address>
Set the RIP cost on a secondary
address
CES(config-if)# ip rip cost <1-15> <secondary
address>
Set the RIP cost for exporting branch
office static routes on a secondary
address
CES(config-if)# ip rip export-bo-static-metric
<1-15> <secondary address>
Stop RIP from exporting branch office
static routes on a secondary address
CES(config-if)# no ip rip export-bo-static-metric
<secondary address>
Set the RIP cost for exporting default
routes on a secondary address
CES(config-if)# ip rip export-default-metric
<1-15> <secondary address>
Stop RIP from exporting default routes
on a secondary address
CES(config-if)# no ip rip export-default-metric
<secondary address>
Set the RIP cost for exporting OSPF
routes on a secondary address
CES(config-if)# ip rip export-ospf-metric <1-15>
<secondary address>
Stop RIP from exporting OSPF routes
on a secondary address
CES(config-if)# no ip rip export-ospf-metric
<secondary address>
Set the RIP cost for exporting Static
routes on a secondary address
CES(config-if)# ip rip export-static-metric
<1-15> <secondary address>
Stop RIP from exporting Static routes
on a secondary address
CES(config-if)# no ip rip export-static-metric
<secondary address>
Enable importing of default routes using
RIP
CES(config-if)# ip rip import-default <secondary
address>
Table 9 Configuring OSPF over a secondary address
Command description Command syntax