Chapter 2 Getting started 45
Nortel VPN Router Configuration — Basic Features
To set an ACL for TELNET, enter the following NNCLI command:
CES(config)#telnet access-list <the_name_of_an_acl>
To remove an ACL for TELNET, enter the following command:
CES(config)#no telnet access-list
Accessing ACL through the GUI:
To access ACLs from the GUI:
1 Select Services > Available. The Allowed Services window appears.
2 Select one of the predefined ACLs.
3 Click OK.
Configuring the serial interface
The Serial Interface allows you to configure the IP address and subnet mask so
that you can then use a Web browser for management.
Your terminal emulator must use the following communications parameters:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• No flow control
The Serial Interface configuration procedure is typically only necessary in a
system recovery situation.
1 Connect the serial cable (supplied with your Nortel VPN Router) from the
Nortel VPN Router serial port to a terminal or a communications port of a PC.
2 Power on the terminal or PC.
To Next Page
Loading...
