Nortel 7 - Using the CLI for SSH Server; Defining an SSH Server (CLI); Enabling or Restarting the SSH Server

Chapter 5 Configuring the system 115
Nortel VPN Router Configuration — Basic Features
Using the CLI for SSH server
Defining an SSH server (CLI)
To configure an SSH server on the Nortel VPN Router, from CLI Global
Configuration Mode, enter:
ssh-server {port <portnum> | private | public }
or
no ssh-server { private | public }
where:
• portnum—specifies the SSH server port
• private—enables private interface filters on the specified SSH server port
• public—enables public interface filters on the specified SSH server port
For example, enter:
CES(config)# ssh-server port 432
Enabling or restarting the SSH server
To enable or restart the SSH server, from CLI Global Configuration Mode, enter:
service ssh {enable | restart}
where:
• enable—enables the ssh server
• restart—restarts the ssh server
For example, to enable the SSH server, enter:
CES(config)# service ssh enable
For example, to restart the SSH server, enter:
CES(config)# service ssh restart