Nortel 7 - Displaying the Current Settings for the SSH Server; Disabling the SSH Server

116 Chapter 5 Configuring the system
NN46110-500
Displaying the current settings for the SSH server
To display the current settings for the SSH server, from CLI Global Configuration
Mode, enter:
show ssh-server { port | state }
where:
• port—shows the SSH server port
• state—specifies the state (enabled or disabled) of the SSH server
For example, to display the current SSH server port for the Nortel VPN Router,
enter:
CES(config)# show ssh-server port
For example, to display the state (enabled or disabled) of the current SSH server
for the Nortel VPN Router, enter:
CES(config)# show ssh-server state
Disabling the SSH server
To disable the SSH server, from CLI Global Configuration Mode, enter:
no service ssh enable
For example, enter:
CES(config)# no service ssh enable