1-2
BioProfile FLEX2 ESM Instructions for Use Manual
8. Place the system away from heat sources.
9. Connect the system to a power supply only of the type described in the operating
instructions or marked on the device.
10. Do not defeat the safety purpose of the polarized or grounding type plug.
11. Route power and communication cords so that they are not likely to be walked on
or pinched by items placed upon or against them, paying particular attention to
cords at plugs, power sockets, and at the point where they exit from the system.
12. The system should be cleaned only as recommended by the manufacturer.
13. Take care not to let objects or liquids fall into the system.
14. The ESM should be serviced only by qualied service personnel.
15. Do not attempt to service the system beyond that described in the operating
instructions. All other servicing should be referred to qualied service personnel.
16. Do not attempt to remove the system cover or the syringe pump safety guard.
Electrical Safety
1. To reduce the risk of electric shock, do not remove the system cover.
2. There are NO operator serviceable parts inside the ESM.
3. Servicing must be performed only by qualied service personnel.
4. Before changing the fuses, unplug the power cord.
5. Replace the fuses with only the same type and rating.
6. To reduce the risk of re or electric shock, do not expose the system to water.
7. The ESM is supplied with a main, non-rewireable plug for the intended country.
8. Ensure that the wall outlet receptacle is properly wired and earth grounded.
9. DO NOT use a 3-to-2 wire plug adapter.
10. DO NOT use a 2-wire extension cord or a 2-wire multiple-outlet power strip.
Chemical and Biological Safety
1. Observe all precautionary information printed on the original reagent container.
2. Operate the system in the appropriate environment.
3. Take all necessary precautions when using toxic materials to prevent the generation
of aerosols.
4. Wear appropriate laboratory attire, e.g., safety glasses, gloves, lab coat, and
breathing apparatus when working with hazardous materials.
5. Dispose of all waste solutions according to company standard operating procedures.
6. The ESM Reagent Cartridge contains a waste pouch where biological material will
be collected. This waste pouch is considered a biohazard and should be disposed
of according to company procedures.
WARNING: Cell culture samples are potential sources of infectious agents. Handle all
sample and ow path components (Sample Cup, Sample Tubing, Reagent
Cartridge, etc.) with care. Gloves and personal protective equipment are
recommended.
To Next Page
Loading...
