PART EDIT SECTION
In solo mode, any currently muted Parts ( not soloed ) are memorised when a performance is saved.
Mute - Button
This button works only in performance mode.
Pressing this button ( Mute button is lit ) activates the Mute mode. When this is active, pressing any Part Mutes it & it flashes.
Unlike solo, exiting the Mute mode by pressing the Mute button again ( Mute button is unlit ) does not cancel the Mute status of the
parts. To un-mute a Part select the Mute mode by pressing the Mute button ( Mute button is lit ) & press the flashing ( muted ) Part.
The Part will stop flashing & become active again. This is so that the Mutes behave like those on a Mixing desk. Additionally, the
Mute Status of each Part is memorised in a Performance so that a Performance can be recalled with some or all Parts muted but
set up & ready to go. Mutes can be transmitted & recorded as controller data to a sequencer & then played back at the Nova.
Whenever a Part is Muted the Program Name display will show “( Muted )” underneath the Program’s name.
To Next Page
Loading...
