SETTING UP
Connect the Master left & Right Audio Outputs ( & the Aux. & Headphones Audio Outputs if required ) of the Nova to a suitable
amplifier or mixing desks stereo inputs & set the Master Volume control on the Nova to a reasonably high output level ( 9 - 10 ).
This will maintain a good signal to noise ratio. Make sure the input volume on your amplifier or mixing desk is initially set to zero.
Make sure that the Nova’s mains switch is in the “OFF” position. Connect the MIDI out of your Master Keyboard or Sequencer to
the MIDI IN on the Nova. Connect the output of the Power Supply unit to the Power In socket on the Nova. Connect the supplied
mains lead to the Mains Socket on the Nova’s Power Supply. Connect the other end to the mains supply & switch the supply on.
The display should now illuminate showing the performance or program that was selected the last time Global data was written into
memory. Refer to page 36 for details on this function. Now switch on your amplifier & adjust the volume accordingly whilst the
Sequencer is playing or you are playing the Master Keyboard.
The Master Keyboard or Sequencer will be playing the currently selected Performance or Program. To listen to all the Factory
sounds, make sure you are in the Performance or Program Mode by pressing the Performance or Program Button & use the Bank
& Prog buttons to the right of the display to call up different sounds.
For details on how to select the different Performances & a Programs & what they are refer to pages 21 for details on Programs &
page 22 for details on Performances.
If no sound is heard, check that you are transmitting on MIDI Channel 1 as the Nova is set-up to receive on MIDI Channel 1 at the
factory.
4
To Next Page
Loading...
Need help?
General
