Page 18 looks like so:
The higher parameter is “Step Note Vel. Gate”. In this case with a value of N
ote.
This parameter determines what type of pattern parameter is going to be edited with the lower Data knob. Use the upper Data
knob to select the parameter to be edited. The cursor indicates the current selection, in this case N
ote. When this parameter is set
to “Step” the value of the parameter below it determines the step to be edited. Use the lower Data knob to adjust this parameter.
The range of this parameter is 01 to 64 but depends on the value set in the “No of Steps” parameter above. When this parameter
is set to “Note” the value of the parameter below it determines the note value of the currently selected step. Use the lower Data
knob to adjust this parameter. The range of this parameter is 01 to 12 for the User Monophonic patterns ( 000 to 063 ) & -36 to +36
for the User Polyphonic patterns ( 064 to 127 ) When this parameter is set to “Vel.” the value of the parameter below it determines
the velocity of the note at the currently selected step. Use the lower Data knob to adjust this parameter. The range of this parame-
ter is 1 to 127. When this parameter is set to “Gate” the value of the parameter below it determines the gate time of the note at the
currently selected step. In the Normal position the gate equals one step unless the following step is a tie. In the Tie position the
notes are tied together. Use the lower Data knob to adjust this parameter. In the Rest position the note is silent. in the Glide posi-
tion the Portamento effect is engaged as it does in Autoglide. The range of this parameter is Norm, Tie, Rest, Glide. Refer to page
25 for details on programming user patterns. These parameters are memorised as Pattern data.
The Note parameter can only be accessed if the current step’s gate is set to Norm or Glide.
To write any changes to the currently selected pattern into memory press the “Write” button while any of the pattern edit pages are
displayed. Also note the “Memory Protect” has to be set to “Off” for this to be possible.
To Next Page
Loading...
