D. Installation Kit
Use only authorized, approved and certified parts for installation and maintenance
of NPS Generators
D.1 NPS Generator should be installed using only NPS authorized parts, installation
equipment and kits as listed below. Failure to do so may void NPS' Limited Warranty and
may result in death or extreme bodily injury to installer or operator
D.2 Any non-motorized RV, to be powered by an NPS Generator Y6000eco, must be
previously prepped with an ECI certified NPS fuel connection system. This requirement
does not apply to motorized RVs. All motorized RV chassis fuel systems are approved
for use with NPS Generator Models Y6000eco. See Exhibit 1.
D.3 Model Y6000eco
• Generator Unit. See Exhibit 2.
• Exhaust Kit. See Exhibit 6.
o
Exhaust Flange to Generator Unit and attached bolts (2)
o
Exhaust Pipe
o
Downpipe (4", 7" or 13") to be selected by installer based on
individual Model application
o
Downpipe Flange and attached bolts (2)
o
Support Strap with Clamp and attached bolts (2)
• NPS Electrical Components. See Exhibits 10, 11, 12, 13, 14.
o
Hand-held Remote Start KeyFob
o
Remote Start Panel
o
Wiring Harness for Remote Panel
o
Liquid-tight Conduit, Connector and Output Leads (pre-attached to
Generator)
• Generator Installation Kit. See Exhibit 5 and Exhibit 16.
o
Bracket Floor Cutout Template
o
Self Tapping Screw (1)
o
Grade 8 Installation Bolts (6)
o
Engine Manual for Yamaha MZ360
P
age 16 of 55 Rev. 1
To Next Page